Carburetor linkage, progressive linkage, multiple

2 x 2 Progressive Made of quality aluminum levers, stainless steel rods & set screws. Standard Kit Part No.2033.......$29.99 Ball Bearing Kit Part No.2034....$34.99
3 x 2 Progressive Low Profile 3 x 2 Progressive Low Profile Ball Bearing 348-409 Chevy. Part No. 2047.............................$59.99
4 x 2 In-line, progressive, 2 Barrel Carbs Holly & Stromberg. Ball Bearing Kit No.2018........................................$75.00
Throttle Rod Linkage Triple Manifold, 12" rod. No. 2128............................................$27.00 Quad Manifold, 14" rod. No. 2129............................................$29.75
Ball Bearing Rod Ends 1/4" / 28 RH No. 2117 ......................$8.99 1/4" / 28 LH No.2118 .......................$8.99
Carb Arms 3/16" Tap Pin No.2130 .....................$4.99 1/4" Tap Pin No.2172 .......................$4.99
Extended Throttle Shafts Extended shaft for stromberg 97, 48 and 81 carbs, Holley 94's, Ford & 210 series Flathead carbs. If you are using these on a multiple carb set-up, you will need these extended shafts. (+ .003 oversize). Stromberg No.2325...................$14.99 Holley No.2323 ..........................$14.99
Throttle Shaft Extensions Our extensions are made of CNC milled brass. The extensions are 5" long with set screw. These are often essential in linking up carbs on Man-A-Fre, McGurk & Weiand 671-6 manifolds where the carbs are side by side but somewhat offset from each other. No.2167 ............................................$7.99
Accelerator Pump Cam, Rochester This cam will clean up the look of your Rochesters and save you time replacing the throttle shafts. It retains the throttle stop and accelerator pump rod provision, but eliminates the unnecessary extras. Bright zinc plated. No.3440 ............................................$3.99
Carb Screw Kits Quality stainless steel for rebuilding your carbs. Holley 94, 2100, 2110 No.3291 .....$3.99 Rochester 2 jet No.3341 .................$3.99 Stromberg EE-1 No.3201 ...............$3.99
Jet Plugs Holley 94, 2100, 2110 No.3204 .........$4.99 Stromberg EE-1 (hexhead) No.3150 ..$10.00
3 x 2 Fuel Block Cast aluminum. Feed intake 3/8 NPT and the ports are 1/4 NPT. Satin No.2653 ............................$35.00
3 Port Fuel Rail 3/8 NPT both ends, 1/4 NPT fuel outlets. Satin No. 2683 ................................$49.99
AIR HORN PLUGS These plugs are most commonly used to plug the air horn when the choke shaft is removed for secondary carburetor operation. May also be used to plug the emission vent on the bowl top. No. 0901 ................................. $0.25 each